Found 5364 results for: Ccna Chapter 7 Exam Answers
[FREE] Ccna Chapter 7 Exam Answers
At what point would a router, which is in the path to the destination device, stop forwarding the packet? When the value in the field reaches zero, the receiving router will not forward the packet, and will send an ICMP Time Exceeded message back to...
Found: 25 May 2021 | Rating: 94/100
[GET] Ccna Chapter 7 Exam Answers
ARPv6 does not exist. Which two things can be determined by using the ping command? Choose two. This can be a measure of network performance. A successful ping also indicates that the destination host was reachable through the network. What is the...
Found: 25 May 2021 | Rating: 98/100
CCNA 1 (v5.1 + V6.0) Chapter 7 Exam Answers For Transport Layer
UDP reassembles the received datagrams in the order they were received. Explain: UDP has no way to reorder the datagrams into their transmission order, so UDP simply reassembles the data in the order it was received and forwards it to the application. What does a client do when it has UDP datagrams to send? It just sends the datagrams. It sends a simplified three-way handshake to the server. It sends to the server a segment with the SYN flag set to synchronize the conversation.
Found: 18 Apr 2021 | Rating: 93/100
CCNA 2 V6.0 Chapter 7 Exam Answers 2021 Full
UDP is the preferred protocol for applications that provide voice or video that cannot tolerate delay. Which three application layer protocols use TCP? Choose three.
Found: 8 Apr 2021 | Rating: 93/100
CCNA3 V6.0 Chapter 7 Exam Answers
Decisions on placing ACLs inbound or outbound are dependent on the requirements to be met. Refer to the exhibit. In the design, the packets would be coming from the The correct ACL is access-list 1 permit Refer to the following output. What is the significance of the 4 match es statement? Four packets have been denied that are destined for the Four packets have been allowed through the router from PCs in the network of Use the no keyword and the sequence number of the ACE to be removed.
Found: 8 Apr 2021 | Rating: 93/100
CCNA Security V Chapter 11 Answers - Implementing Network Security
Create a second access list denying the host and apply it to the same interface. Add a deny any any ACE to access-list 1. Because the new deny ACE is a host address that falls within the existing For the new deny ACE to take effect, it must be manually configured by the administrator with a sequence number that is less than A network administrator issues the show vlan brief command while troubleshooting a user support ticket.
Found: 21 Apr 2021 | Rating: 85/100
CCNA V Exam Answers - Full Labs, Material, Assignments
ARPv6 does not exist. Which two things can be determined by using the ping command? Choose two. This can be a measure of network performance. A successful ping also indicates that the destination host was reachable through the network. What is the purpose of ICMP messages? What is indicated by a successful ping to the IPv6 address?
Found: 21 Apr 2021 | Rating: 90/100
Ccna 1 V Chapter 7 Exam Answers
The host is cabled properly. The default gateway address is correctly configured. All hosts on the local link are available. The link-local address is correctly configured. IP is properly installed on the host. Explanation: The IPv6 address is the loopback address. It does not mean that any addresses are correctly configured. A user is executing a tracert to a remote device. At what point would a router, which is in the path to the destination device, stop forwarding the packet? When the value in the field reaches zero, the receiving router will not forward the packet, and will send an ICMP Time Exceeded message back to the source.
Found: 18 Apr 2021 | Rating: 92/100
CCNA3 V Chapter 7 Exam Answers - CCNA ANSWER
What happens if the first packet of a TFTP transfer is lost? The client will wait indefinitely for the reply. The TFTP application will retry the request if a reply is not received. The transport layer will retry the query if a reply is not received. What does a client do when it has UDP datagrams to send? It just sends the datagrams. It sends a simplified three-way handshake to the server. It sends to the server a segment with the SYN flag set to synchronize the conversation. A technician wishes to use TFTP to transfer a large file from a file server to a remote router. Which statement is correct about this scenario?
Found: 10 Apr 2021 | Rating: 90/100
No comments:
Post a Comment